Talk:Subtractor

	Electronics portal This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic
???	This article has not yet received a rating on the project's importance scale.

Can the Subtracter (electronics) be explained with circuits and truth tables the same way as the Adder (electronics)(http://wiki.riteme.site/wiki/Full_adder)?

a subtractor is basically just an adder with one input inverted and the first carry in set to 1 rather than 0.

Full Subtractor

the truth table for full subtractor is not correct; read this => http://www.doc.ic.ac.uk/~dfg/hardware/HardwareLecture13.pdf 60.48.175.38 (talk) 18:57, 26 September 2011 (UTC)[reply]

Note, the full substractor graphic is wrong. The first inversor goes in the A imput. If the subtrahend is 0 and the minuend is 1, it triggers the borrow out. — Preceding unsigned comment added by Mbertelotti (talk • contribs) 20:42, 22 April 2013 (UTC)[reply]

Half subtractor diagram

The diagram should be replaced such that the X input is the minuend and Y is the subtrahend. Doing it this way would make the diagram consistent with the article and the following explanation unnecessary:

An important point worth mentioning is that the half subtractor diagram aside implements $Y-X$ and not $X-Y$ since $B_{\text{out}}$ on the diagram is given by

$B_{\text{out}}=X\cdot {\overline {Y}}$ .

This is an important distinction to make since subtraction itself is not commutative, but the difference bit $D$ is calculated using an XOR gate which is commutative.

We could still have a footnote that says whichever input is inverted is the minuend. --Usability (talk) 07:40, 1 November 2015 (UTC)[reply]