Talk:Push–pull converter

A fact from Push–pull converter appeared on Wikipedia's Main Page in the Did you know column on 5 February 2006. The text of the entry was as follows:

Did you know... that a Push-Pull Converter is a type of DC to DC converter that uses a transformer to step the voltage of a DC power supply?

A record of the entry may be seen at Wikipedia:Recent additions/2006/February.

Wikipedia

Energy Low‑importance

	Energy portal This article is within the scope of WikiProject Energy, a collaborative effort to improve the coverage of Energy on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.EnergyWikipedia:WikiProject EnergyTemplate:WikiProject Energyenergy articles
Low	This article has been rated as Low-importance on the project's importance scale.

Electrical engineering Low‑importance

	Engineering portal This article is within the scope of WikiProject Electrical engineering, a collaborative effort to improve the coverage of Electrical engineering on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.Electrical engineeringWikipedia:WikiProject Electrical engineeringTemplate:WikiProject Electrical engineeringelectrical engineering articles
Low	This article has been rated as Low-importance on the project's importance scale.

Timing logic backwards

It seems to me that having both transistors closed (on) would result in a short across the supply rail? --njh 01:25, 30 April 2007 (UTC)[reply]

I think there is some non-standard terminology at work here... the article uses "closed" to indicate a high-impedance (off) state, and "open" to indicate a low-impedance (on) state.

- Dwight Larson

- - There are many problems with this description. They actually describe a full-bridge forward converter, not a push-pull. —Preceding unsigned comment added by 128.174.111.17 (talk) 00:01, 25 January 2009 (UTC)[reply]

Comments

1. A better and more specific image could be used for the circuit. Since the whole transistor operation is explained, then the article might as well have a schematic that shows how the transistors replace the switches in the current image.

2. The "Circuit operation" and "Timing" sections should probably be renamed "Circuit" and "Operation" which I think more appropriate.

ICE77 (talk) 18:03, 14 January 2012 (UTC)[reply]