Talk:Outline of metalworking

Outlines High‑importance

	This article is an outline, a type of article that presents a list of articles or sub-topics related to its subject in a hierarchical form. For the standardized set of outlines on Wikipedia, see Wikipedia:Contents/Outlines. Outlines are within the scope of WikiProject Outlines, a collaborative effort to improve outlines on Wikipedia. For guidance on building and maintaining outlines, see Wikipedia:Outlines.OutlinesWikipedia:WikiProject OutlinesTemplate:WikiProject OutlinesOutlines articles
High	This article has been rated as High-importance on the importance scale.

Metalworking Mid‑importance

	This article is within the scope of WikiProject Metalworking, a collaborative effort to improve the coverage of Metalworking on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.MetalworkingWikipedia:WikiProject MetalworkingTemplate:WikiProject MetalworkingMetalworking articles
Mid	This article has been rated as Mid-importance on the project's importance scale.

Glossaries (inactive)

This article is within the scope of WikiProject Glossaries, a project which is currently considered to be inactive.GlossariesWikipedia:WikiProject GlossariesTemplate:WikiProject GlossariesGlossaries articles

Untitled

bigtime work in progress need lots of defs and whatnot, but almost everything mentioned so far has an article that mmentions it. when i get some more time and finish up my thermo hw ill ahve more time to flesh this list out.

Any suggestions as to wether to approach this from a metallurgy or a metalworking prepective? they are different things. --Meawoppl 02:08, 9 November 2005 (UTC)[reply]

I noticed that the measurement heading was used and then it listed a bunch of things that can be measured. I feel a better heading for this may be Physical Properties. Oil/air/work hardneing and other things listed are functions of the physical property of the material. When I think of measurement with metal working I immediately think of calipers, micrometers, height gages, ring and plug gages, thread gages, etc.

- BaudEagle 5/2/06

Maybe the bending section should be linked to the wiki page on metalworking bending rather than the wiki page on general bending? What do you think? http://wiki.riteme.site/wiki/Bending_(metalworking) 195.38.107.244 (talk) 19:19, 16 November 2020 (UTC)[reply]