Jump to content

Talk:MAP sensor

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

Manifold absolute pressure sensor.....how do you know if it is bad or going bad? Also, will a bad sensor cause the vehicle to stop spontaneously?

I'm curious about the use of quotation marks in the equations listed. Are these supposed to be equal signs instead? —Preceding unsigned comment added by 198.68.164.84 (talk) 23:56, 12 May 2008 (UTC)[reply]

MAP or MAF

[edit]

Which of two sensors is better? I mean more reliable, gives better dynamic etc... —Preceding unsigned comment added by 95.30.109.78 (talk) 18:13, 5 July 2009 (UTC)[reply]


Normaly you will have vehicles with MAF sensor and after, if you decide you want to cut the cost you could do some tunning and you will put the MAP sensor (for the diesel engine) —Preceding unsigned comment added by 92.81.67.247 (talk) 20:14, 13 August 2009 (UTC)[reply]

no fuel....87 GMC v3500 7.4-454 dually w/dual tanks

[edit]

ok, here's a dumb question. I should know this, but I'm having a brain blank. I'm not getting fuel to the TBI, and I don't hear any priming from the pumps. the relays are fine, I can hear and feel them click. all of the fuses are good under the dash. ive checked the ignition mod, its good. my next step is the map sensor unless you all tell me diffrnt. if that's good, im going to the pumps. I know the map sensor controls fuel, but again, I cant hear the pumps. both tanks are 1/4 full. HELP!!!!! brian. — Preceding unsigned comment added by 174.29.25.205 (talk) 04:20, 21 January 2014 (UTC)[reply]


Make sure your fuel switch is on a tank and not accidently moved to the middle where it would be on neither tank