This article is within the scope of WikiProject Chemical and Bio Engineering, a project which is currently considered to be inactive.Chemical and Bio EngineeringWikipedia:WikiProject Chemical and Bio EngineeringTemplate:WikiProject Chemical and Bio EngineeringChemical and Bio Engineering articles

Technology C‑class

	Technology portal This article is within the scope of WikiProject Technology, a collaborative effort to improve the coverage of technology on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.TechnologyWikipedia:WikiProject TechnologyTemplate:WikiProject TechnologyTechnology articles
C	This article has been given a rating which conflicts with the project-independent quality rating in the banner shell. Please resolve this conflict if possible.

I have cleaned up the page. I have made it flow better, and organized it more logically. In doing this, I have put the bit about the injection molding process (versus the properties of the products) into its own section. I have also removed excessive links.

It appears that the original text is citing the "International Plastics Handbook". I'm going to cite it as the source.

Georgesch4 20:22, 3 November 2006 (UTC)[reply]

Wikishness in question

Is this really wikiworthy?

'A good cold runner is expensive as compared to conventional hot runner tooling, and will provide a high level of performance IF IT IS PROPERLY MAINTAINED. Unfortunately in my experience this is not usually the case.' — Preceding unsigned comment added by 165.228.233.174 (talk) 07:07, 18 October 2011 (UTC)[reply]