Talk:Drawing board

Architecture Mid‑importance

	Architecture portal This article is within the scope of WikiProject Architecture, a collaborative effort to improve the coverage of Architecture on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.ArchitectureWikipedia:WikiProject ArchitectureTemplate:WikiProject ArchitectureArchitecture articles
Mid	This article has been rated as Mid-importance on the project's importance scale.

Technology

This article is within the scope of WikiProject Technology, a collaborative effort to improve the coverage of technology on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.TechnologyWikipedia:WikiProject TechnologyTemplate:WikiProject TechnologyTechnology articles

Second heading

What the carp is wrong with it? It currently reads:

Dimensions of Engineering Drawing Boards (IS1444:1989) Refer Engineering Drawing Basant Agrawal on googlebook page 1.2 Designation D00 length 1525 mm width 1220 mm thickness 22 mm Designation D0 length 1270 mm width 920 mm thickness 22 mm Designation D1 length 920 mm width 650 mm thickness 22 mm Designation D2 length 650 mm width 470 mm thickness 22 mm Designation D3 length 500 mm width 350 mm thickness 22 mm

This is utterly incomprehensible to me, and the linebreaks are not carrying over in formatting from the editing page to the article itself, so any sense of flow within the specifications it looks to be attempting to provide is completely lost. It may be that I just don't understand, but this really doesn't seem to belong, especially in its current state. Anyone care to explain/fix/remove? 98.173.209.210 (talk) 07:19, 9 December 2010 (UTC)[reply]