Talk:Annular cutter

Metalworking Low‑importance

	This article is within the scope of WikiProject Metalworking, a collaborative effort to improve the coverage of Metalworking on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.MetalworkingWikipedia:WikiProject MetalworkingTemplate:WikiProject MetalworkingMetalworking articles
Low	This article has been rated as Low-importance on the project's importance scale.

Engineering Mid‑importance

	Engineering portal This article is within the scope of WikiProject Engineering, a collaborative effort to improve the coverage of engineering on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.EngineeringWikipedia:WikiProject EngineeringTemplate:WikiProject EngineeringEngineering articles
Mid	This article has been rated as Mid-importance on the project's importance scale.

Talk

This article is an embarrassment. This is without a doubt the worst article I have ever read on wikipedia. It REALLY needs to be deleted or seriously cleaned up!

Poopmanturdhead — Preceding unsigned comment added by 18.111.30.249 (talk) 21:47, 3 December 2015 (UTC)[reply]

Poor Content Quality - Descriptions and Tool Examples are not consistent.

The original writer states that an annular cutter only uses a single cut and does not require pre-drilling. However, in the tool examples each tool has a guide hole at the center which is consistent with a hole saw (similar to tool used for a deadbolt lock or door handle) but based on the tool examples the angular drill used a predrilled hold which is used to center the angular drill (which itself creates cuts the circumference of the hole) and results in a stable cut. I would expect this would be because without this centering hole it would difficult to keep the material or cutting head from "skating" along the surface of the metal being cut until a groove is established to keep the drill in a set area, a centering hole also would prevent the material from moving relative to the hole and prevent the drill binding in the material from it being moved out of center or off axis. These are only my thoughts, but they seem to correspond with the reference pictures. In any case the article should be scrapped and removed if reliable content which corresponds with the graphics can be provided or explained with reference.wizbang_fl 04:36, 8 September 2019 (UTC) — Preceding unsigned comment added by Jatibi (talk • contribs)

Written like an ad.

A majority of the article seems more like an opinion piece or a sales pitch rather than an unbiased and reliable page. There is a whole section dedicated to the benefits of using an annular cutter, which i'm tempted to delete because it doesn't seem necessary. Either that, or reword a majority of the section to get rid of the "advertisement" feel. Just a bit silly (talk) 16:58, 15 December 2022 (UTC)[reply]