Jump to content

Incremental dynamic analysis

From Wikipedia, the free encyclopedia

Incremental dynamic analysis (IDA) is a computational analysis method of earthquake engineering for performing a comprehensive assessment of the behavior of structures under seismic loads.[1] It has been developed to build upon the results of probabilistic seismic hazard analysis in order to estimate the seismic risk faced by a given structure. It can be considered to be the dynamic equivalent of the static pushover analysis.

Description

[edit]

IDA involves performing multiple nonlinear dynamic analyses of a structural model under a suite of ground motion records, each scaled to several levels of seismic intensity. The scaling levels are appropriately selected to force the structure through the entire range of behavior, from elastic to inelastic and finally to global dynamic instability, where the structure essentially experiences collapse. Appropriate postprocessing can present the results in terms of IDA curves, one for each ground motion record, of the seismic intensity, typically represented by a scalar Intensity Measure (IM), versus the structural response, as measured by an engineering demand parameter (EDP).

Possible choices for the IM are scalar (or rarely vector) quantities that relate to the severity of the recorded ground motion and scale linearly or nonlinearly with its amplitude. The IM is properly chosen well so that appropriate hazard maps (hazard curves) can be produced for them by probabilistic seismic hazard analysis. In addition, the IM should be correlated with the structural response of interest to decrease the number of required response history analyses.[2] Possible choices are the peak ground acceleration, peak ground velocity or Arias intensity, but the most widely used is the 5%-damped spectral acceleration at the first-mode period of the structure. The results of the recent studies show that spectrum intensity (SI) is an appropriate IM.[2]

The EDP can be any structural response quantity that relates to structural, non-structural or contents' damage. Typical choices are the maximum (over all stories and time) interstory drift, the individual peak story drifts and the peak floor accelerations.

Development history

[edit]

IDA grew out of the typical practice of scaling accelerograms by multiplying with a constant factor to represent more or less severe ground motions than the ones that were recorded at a site. Since the natural recordings available are never enough to cover all possible needs, scaling is a simple, yet potentially problematic method (if misused) to "fill-in" gaps in the current catalog of events. Still, in most cases, researchers would scale only a small set of three to seven records and typically only once, just to get an estimate of response in the area of interest.

In the wake of the damage wrought by the 1994 Northridge earthquake, the SAC/FEMA project[3] was launched to resolve the issue of poor performance of steel moment-resisting frames due to the fracturing beam-column connections. Within the creative environment of research cooperation, the idea of subjecting a structure to a wider range of scaling emerged. Initially, the method was called Dynamic Pushover[4] and it was conceived as a way to estimate a proxy for the global collapse of the structure. It was later recognized that such a method would also enable checking for multiple limit-states, e.g. for life-safety, as is the standard for most seismic design methods, but also for lower and higher levels of intensity that represent different threat levels, such as immediate-occupancy and collapse-prevention. Thus, the idea for Incremental Dynamic Analysis[1] was born, which was mainly adopted and later popularized by researchers at the John A. Blume Earthquake Research Center of Stanford University. This has now met with wider recognition in the earthquake research community and has spawned several different methods and concepts for estimating structural performance.

A substantial debate has been raised regarding the potential bias in the IDA results due to using the scaled ground motions records that do not appropriately characterize the seismic hazard of the considered site over different earthquake intensity levels.[5][6][7][8]

See also

[edit]

References

[edit]
  1. ^ a b Vamvatsikos D., Cornell C.A. (2002). Incremental Dynamic Analysis. Earthquake Engineering and Structural Dynamics, 31(3): 491–514.
  2. ^ a b Kiani, Jalal; Pezeshk, Shahram (2017). "Sensitivity analysis of the seismic demands of RC moment resisting frames to different aspects of ground motions". Earthquake Engineering & Structural Dynamics. 46 (15): 2739–2755. Bibcode:2017EESD...46.2739K. doi:10.1002/eqe.2928. ISSN 1096-9845. S2CID 96452142.
  3. ^ SAC/FEMA (2000). Recommended seismic design criteria for new steel moment-frame buildings, Report No. FEMA-350, and Recommended seismic evaluation and upgrade criteria for existing welded steel moment-frame buildings, Report No. FEMA-351, SAC Joint Venture, Federal Emergency Management Agency, Washington, DC.
  4. ^ Luco N., Cornell CA. (1998) Effects of random connection fractures on demands and reliability for a 3-storey pre-Northridge SMRF structure. Proceedings of the 6th U.S. National Conference on Earthquake Engineering, paper 244, Seattle, WA.
  5. ^ Baker, Jack W.; Allin Cornell, C. (25 July 2006). "Spectral shape, epsilon and record selection". Earthquake Engineering & Structural Dynamics. 35 (9): 1077–1095. Bibcode:2006EESD...35.1077B. CiteSeerX 10.1.1.585.7815. doi:10.1002/eqe.571. ISSN 1096-9845. S2CID 426019.
  6. ^ Bradley, Brendon A. (1 September 2013). "A critical examination of seismic response uncertainty analysis in earthquake engineering". Earthquake Engineering & Structural Dynamics. 42 (11): 1717–1729. Bibcode:2013EESD...42.1717B. doi:10.1002/eqe.2331. hdl:10092/8700. ISSN 1096-9845. S2CID 59370811.
  7. ^ Kiani, Jalal; Khanmohammadi, Mohammad (19 May 2015). "New Approach for Selection of Real Input Ground Motion Records for Incremental Dynamic Analysis (IDA)". Journal of Earthquake Engineering. 19 (4): 592–623. doi:10.1080/13632469.2014.997901. ISSN 1363-2469. S2CID 110763954.
  8. ^ Lin, T. and Baker, J. W. [2013] "Introducing Adaptive Incremental Dynamic Analysis: A new tool for linking ground motion selection and structural response assessment,” 11th International Conference on Structural Safety & Reliability, New York.
[edit]