6AK5
This article has multiple issues. Please help improve it or discuss these issues on the talk page. (Learn how and when to remove these messages)
|
The 6AK5 vacuum tube is a miniature 7-pin sharp-cutoff pentode used as RF or IF amplifier especially in high-frequency wide-band applications at frequencies up to 400 MHz.
It was developed by Bell Labs / Western Electric and used extensively as an I.F. amplifier in World War II radar systems. The tube is notable for its extremely fine grid, and extremely close control grid to cathode spacing, yielding excellent high-frequency performance.
It is also known as EF95 under its Mullard–Phillips designation and was produced in the former Soviet Union as type 6Zh1P (Russian: 6Ж1П) under the Russian designation system.
A version of this tube with extended ratings was designated 6AK5W and 6Zh1P-EV (Russian: 6Ж1П-ЕВ) respectively.
Even though primarily intended for VHF amplification, the tube has found some use in audio applications as a microphone preamplifier, for instance in the LOMO 19A9 microphone, headphone amplifiers such as the Little Dot MKIII, and in guitar effects stompboxes, such as Metasonix TM-7 Scrotum Smasher.[citation needed]
The 6AK5 was used in some types of radiosonde (weather balloon payloads), in the 1960s and 70s. Because of the non-recoverable nature of the equipment, the single 6AK5 was soldered directly to the printed circuit board and served as the only active device in the circuit, performing the function of a low frequency modulation oscillator and the high frequency carrier oscillator and output stage.
See also
[edit]References
[edit]
External links
[edit]- Data sheets:
- Standard version - 6AK5/EF95
- Premium version - 6AK5W/5654/6096
- PCB version - 7430
- 6AK5 at the National Valve Museum
- http://www3.alcatel-lucent.com/bstj/vol25-1946/articles/bstj25-3-385.pdf[permanent dead link ]
- Reviews of 6ak5 tubes.