Jump to content

UA120

From Wikipedia, the free encyclopedia
(Redirected from UA1205)
Launch of a Titan 34D with two UA1206 boosters

UA120 was a family of American solid rocket boosters, manufactured by the Chemical Systems Division of United Aircraft (later United Technologies Corporation). Several variants existed, with a varying number of segments.

Design

[edit]
Schematic of the UA120 booster

All versions of UA120 shared a common design, with the only significant differentiating factor being the length of the motor. It was a segmented design, with between five and seven motor segments possible. A solid propellant used was a ammonium perchlorate composite propellant with polybutadiene acrylonitrile (PBAN) binder.[1] The stage had an external diameter of 120 inches.[2] Attitude control in flight was provided by means of a liquid injection thrust vector control (LITVC) system, with an external nacelle containing nitrogen tetroxide attached to the side of each booster.[2] Solid fueled separation rockets, used to jettison the spent boosters, were affixed at the top and bottom of the stage.[2] Thrust-termination capability, necessary for crewed rockets such as the Space Shuttle or Manned Orbiting Laboratory, was to be provided by two pyrotechnically triggered ports on the forward closure, which when opened would allow for the non-propulsive venting of exhaust gasses.[3] The forward end of the stage contained an aerodynamic nose cone, an ignitor, separation rockets, and the forward attachment ring. The aft end contained additional separation rockets, the nozzle, and a heat shield.[2]

Variants

[edit]

The overall design of each variant was very similar, the main difference being the number of segments used. This is indicated by the number at the end of each designation.

UA1205

[edit]

UA1205 was used as a strap-on booster on the Titan IIIC, Titan IIID, and Titan IIIE rockets, and was proposed for use on several derivatives of the Saturn rocket family.[1][2]

UA1206

[edit]

The UA1206 was used as a strap-on booster on Titan 34D and Commercial Titan III.[4]

UA1207

[edit]

UA1207 was used on Titan IV-A. It was proposed for several other variants of Titan III and IV, as well as derivatives of the Saturn rocket family and the Space Shuttle.[2][3][5]

References

[edit]
  1. ^ a b "UA1205". Astronautix. Archived from the original on March 1, 2002. Retrieved 26 February 2016.
  2. ^ a b c d e f "A STUDY OF PERFORMANCE AND COST IMPROVEMENT POTENTIAL OF THE 120-IN.- (3.05 M) DIAMETER SOLID ROCKET MOTOR" (PDF). United Aircraft Corporation. December 1971. Retrieved 26 February 2016.
  3. ^ a b "Study of Solid Rocket Motors for a Space Shuttle Booster" (PDF). United Technology Center. 15 March 1972. Retrieved 26 February 2016.
  4. ^ "Titan UA1206". Astronautix. Archived from the original on February 8, 2002. Retrieved 26 February 2016.
  5. ^ "UA1207". Astronautix. Archived from the original on 4 March 2016. Retrieved 26 February 2016.