Jump to content

Santana 25

From Wikipedia, the free encyclopedia
(Redirected from Santana 25-2)

Santana 25-1
Development
DesignerW. Shad Turner
LocationUnited States
Year1973
No. built160
Builder(s)W. D. Schock Corp
RoleRacer
NameSantana 25-1
Boat
Displacement4,050 lb (1,837 kg)
Draft4.08 ft (1.24 m)
Hull
Typemonohull
Constructionfiberglass
LOA24.58 ft (7.49 m)
LWL19.50 ft (5.94 m)
Beam7.82 ft (2.38 m)
Engine typeoutboard motor
Hull appendages
Keel/board typefin keel
Ballast1,800 lb (816 kg)
Rudder(s)transom-mounted rudder
Rig
Rig typeBermuda rig
I foretriangle height31.16 ft (9.50 m)
J foretriangle base10.00 ft (3.05 m)
P mainsail luff27.00 ft (8.23 m)
E mainsail foot7.83 ft (2.39 m)
Sails
Sailplanmasthead sloop
Mainsail area105.71 sq ft (9.821 m2)
Jib/genoa area155.80 sq ft (14.474 m2)
Total sail area261.51 sq ft (24.295 m2)
Racing
PHRF222

The Santana 25 is an American trailerable sailboat that was designed by W. Shad Turner as an International Offshore Rule Quarter Ton class racer and first built in 1973. The boat was Turner's first design.[1][2][3][4]

Production

[edit]

The design was built by W. D. Schock Corp in the United States, from 1973 to 1977 but it is now out of production.[1][2][4][5]

Design

[edit]

The Santana 25 is a recreational keelboat, built predominantly of fiberglass, with wood trim. It has a masthead sloop rig, a raked stem, a reverse transom, a transom-hung rudder controlled by a tiller and a fixed fin keel or swing keel. The fixed keel model displaces 4,050 lb (1,837 kg) and carries 1,800 lb (816 kg) of ballast, while the swing keel model displaces 3,600 lb (1,633 kg) and carries 1,370 lb (621 kg) of ballast. The swing keel model also has less sail area.[1][2][4]

The keel-equipped version of the boat has a draft of 4.08 ft (1.24 m), while the swing keel-equipped version has a draft of 5.5 ft (1.7 m) with the centerboard extended and 2.58 ft (0.79 m) with it retracted, allowing operation in shallow water, beaching or ground transportation on a trailer.[1][2][4]

The boat is normally fitted with a small 6 to 8 hp (4 to 6 kW) outboard motor for docking and maneuvering.[1][4]

The design has sleeping accommodation for four people, with a double "V"-berth in the bow cabin and two straight settees in the main cabin along with a swing table. The galley is located on both sides at the companionway ladder. The head is located just aft of the bow cabin on the starboard side. Cabin headroom is 62 in (157 cm).[1][4]

The design has a PHRF racing average handicap of 222 and a hull speed of 5.9 kn (10.9 km/h).[4]

Variants

[edit]
Santana 25-1
This model was introduced in 1973 and produced until 1977 with 160 boats completed. It has a cast iron keel.[1][6]
Santana 25-2
This model was introduced in 1973. It has a revised cabin top and deck design, plus a lead keel.[2]

Operational history

[edit]

The boat is supported by an active class club that organizes racing events, the Quarter Ton Class.[7]

See also

[edit]

References

[edit]
  1. ^ a b c d e f g McArthur, Bruce (2021). "Santana 25-1 sailboat". sailboatdata.com. Archived from the original on 20 December 2021. Retrieved 20 December 2021.
  2. ^ a b c d e McArthur, Bruce (2021). "Santana 25-2 sailboat". sailboatdata.com. Archived from the original on 20 December 2021. Retrieved 20 December 2021.
  3. ^ McArthur, Bruce (2021). "W. Shad Turner". sailboatdata.com. Archived from the original on 29 August 2020. Retrieved 20 December 2021.
  4. ^ a b c d e f g Henkel, Steve: The Sailor's Book of Small Cruising Sailboats, page 366. International Marine/McGraw-Hill, 2010. ISBN 978-0-07-163652-0
  5. ^ McArthur, Bruce (2020). "Schock W.D." sailboatdata.com. Archived from the original on 18 July 2020. Retrieved 20 December 2021.
  6. ^ W. D. Schock Corp. "Boats built by W.D. Schock". wdschock.com. Archived from the original on 21 February 2010. Retrieved 9 August 2022.
  7. ^ McArthur, Bruce (2021). "Quarter Ton Class". sailboatdata.com. Archived from the original on 29 January 2021. Retrieved 20 December 2021.
[edit]