Radioactive contamination

The radiation warning symbol (trefoil).

File:Periodic Tablezxczxczxcxczxc Radioactivity.svg

Periodic table with elements colored according to the half-life of their most stable isotope.

  Stable elements;

  Radioactive elements with very long-lived isotopes. Their half-live of over four million years confers them very small, if not negligible radioactivities;

  Radioactive elements that may present low health hazards. Their most stable isotopes have half-lives between 800 and 34.000 years. Because of this, they usually have some commercial applications;

  Radioactive elements that are known to pose high safety risks. Their most stable isotopes have half-lifes between one day and 103 years. Their radioactivities confers them little potential for commercial uses;

  Highly radioactive elements. Their most stable isotopes have half-lifes between one day and several minutes. They pose severe health risks. Few of them receive uses outside basic research;

  Extremely radioactive elements. Very little is known about these elements due to their extreme instability and radioactivity.

Radioactive contamination, also called radiological contamination, is the uncontrolled distribution of radioactive material in a given environment. The amount of radioactive material released in an accident is called the source term.

Sources of contamination

Radioactive contamination is typically the result of a spill or accident during the production or use of radionuclides (radioisotopes), an unstable nucleus which has excessive energy. Contamination may occur from radioactive gases, liquids or particles. For example, if a radionuclide used in nuclear medicine is accidentally spilled, the material could be spread by people as they walk around. Radioactive contamination may also be an inevitable result of certain processes, such as the release of radioactive xenon in nuclear fuel reprocessing. In cases that radioactive material cannot be contained, it may be diluted to safe concentrations. Nuclear fallout is the distribution of radioactive contamination by a nuclear explosion. For a discussion of environmental contamination by alpha emitters please see actinides in the environment. Containment is what differentiates radioactive material from radioactive contamination. Therefore, radioactive material in sealed and designated containers is not properly referred to as contamination, although the units of measurement might be the same.

Measurement

Radioactive contamination may exist on surfaces or in volumes of material or air. In a nuclear power plant, detection and measurement of radioactivity and contamination is often the job of a Certified Health Physicist.

Surface contamination

Surface contamination is usually expressed in units of radioactivity per unit of area. For SI, this is becquerels per square meter (or Bq/m²). Other units such as picoCuries per 100 cm² or disintegrations per minute per square centimeter (1 dpm/cm² = 166 2/3 Bq/m²) may be used. Surface contamination may either be fixed or removable. In the case of fixed contamination, the radioactive material cannot by definition be spread, but it is still measurable.

Hazards

In practice there is no such thing as zero radioactivity. Not only is the entire world constantly bombarded by cosmic rays, but every living creature on earth contains significant quantities of carbon-14 and most (including humans) contain significant quantities of potassium-40. These tiny levels of radiation are not any more harmful than sunlight, but just as excessive quantities of sunlight can be dangerous, so too can excessive levels of radiation.

Low level contamination

The hazards to people and the environment from radioactive contamination depend on the nature of the radioactive contaminant, the level of contamination, and the extent of the spread of contamination. Low levels of radioactive contamination pose little risk, but can still be detected by radiation instrumentation. In the case of low-level contamination by isotopes with a short half-life, the best course of action may be to simply allow the material to naturally decay. Longer-lived isotopes should be cleaned up and properly disposed of, because even a very low level of radiation can be life-threatening when in long exposure to it.

High level contamination

High levels of contamination may pose major risks to people and the environment. People can be exposed to potentially lethal radiation levels, both externally and internally, from the spread of contamination following an accident (or a deliberate initiation) involving large quantities of radioactive material. The biological effects of external exposure to radioactive contamination are generally the same as those from an external radiation source not involving radioactive materials, such as x-ray machines, and are dependent on the absorbed dose.

Biological effects

See also: Radiation poisoning

The biological effects of internally deposited radionuclides depend greatly on the activity and the biodistribution and removal rates of the radionuclide, which in turn depends on its chemical form. The biological effects may also depend on the chemical toxicity of the deposited material, independent of its radioactivity. Some radionuclides may be generally distributed throughout the body and rapidly removed, as is the case with tritiated water. Some radionuclides may target specific organs and have much lower removal rates. For instance, the thyroid gland takes up a large percentage of any iodine that enters the body. If large quantities of radioactive iodine are inhaled or ingested, the thyroid may be impaired or destroyed, while other tissues are affected to a lesser extent. Radioactive iodine is a common fission product; it was a major component of the radiation released from the Chernobyl disaster, leading to nine fatal cases of pediatric thyroid cancer and hypothyroidism. On the other hand, radioactive iodine is used in the diagnosis and treatment of many diseases of the thyroid precisely because of the thyroid's selective uptake of iodine.

Means of contamination

Radioactive contamination can enter the body through ingestion, inhalation, absorption, or injection. For this reason, it is important to use personal protective equipment when working with radioactive materials. Radioactive contamination may also be ingested as the result of eating contaminated plants and animals or drinking contaminated water or milk from exposed animals. Following a major contamination incident, all potential pathways of internal exposure should be considered.

See also

• Background radiation
• Chernobyl disaster
• Criticality accident
• Exotic pollution
• Ionizing Radiation (includes physicists' units of radiation exposure)
• Nuclear and radiation accidents
• Nuclear debate (disambiguation)
• Nuclear power
• Radiation biology
• Radiation exposure (disambiguation)
• Radiation poisoning
• Radioactive waste
• Radiophobia
• Relative Biological Effectiveness
• Rongelap Atoll