Muon collider
A Muon Collider is a proposed particle accelerator facility in its conceptual design stage that collides muon beams for precision studies of the Standard Model and for direct searches of new physics. Muons belong to the second generation of leptons; they are typically produced in high-energy collisions either naturally (for example by collisions of cosmic rays with the Earth's atmosphere) or artificially (in controlled environments using particle accelerators). The main challenge of such a collider is the short lifetime of muons.
Previous lepton colliders have all used electrons and/or their anti-particles, positrons. They offer an advantage over hadron colliders, such as the CERN-based Large Hadron Collider, in that lepton collisions are relatively "clean" thanks to leptons being elementary particles, while hadrons, such as protons, are composite particles. Yet electron-positron colliders cannot efficiently reach the same centre-of-mass energy as hadron colliders in circular accelerators due to their energy loss through synchrotron radiation.
A muon is about 206 times more massive than the electron, which reduces the amount of synchrotron radiation from a muon by a factor of about 1 billion. The reduced radiation loss enables the construction of circular colliders with much higher design energies than equivalent electron-positron colliders. This provides the unique combination of high centre-of-mass energy and clean collision environment that is not achievable in any other type of particle collider. It has been shown that a muon collider could achieve energies of several teraelectronvolt (TeV).[1] In particular, starting from the centre-of-mass energy of 3 TeV, a muon collider is the most energy-efficient type of collider, while at 10 TeV it would have a physics reach comparable to that of the proposed 100 TeV hadron collider, FCC-hh,[2] while fitting in a ring of the size of the LHC (27 kilometres (17 mi)), without the need for a much-more-expensive 100-kilometre-long (62 mi) long tunnel foreseen for the Future Circular Collider. A muon collider also provides a clean and effective way to produce Higgs bosons.[3]
Muons are short-lived particles with a lifetime of 2.2 μs in their rest frame. This fact poses a serious challenge for the accelerator complex: muons must be accelerated to a high energy before they decay, and the accelerator needs a continuous source of new muons. It also impacts the experiment design: a high flux of particles induced by the muon decay products eventually reaches the detector, requiring advanced detector technologies and event-reconstruction algorithms to distinguish these particles from collision products. The baseline muon-production method considered today[when?] is based on a high-energy proton beam impinging on a target to produce pions, which then decay to muons that have a sizeable spread of direction and energy, which needs to be reduced for further acceleration in the ring. The possibility of performing this so-called 6D cooling of muons has been demonstrated by the Muon Ionisation Cooling Experiment (MICE).[4] An alternative production method, Low Emittance Muon Accelerator (LEMMA),[5] uses a positron beam impinging on a fixed target to produce muon pairs from the electron-positron annihilation process at the threshold centre-of-mass energy. The resulting beam does not need the cooling stage, but suffers from a very low muon-production cross section, making it challenging to achieve high luminosity with existing positron sources.
Talks were proceeding in 2009.[6][7] The first dedicated design of the accelerator complex and detector design for the centre-of-mass energies up to 3 TeV was developed within the American Muon Accelerator Program (MAP) during 2010–2015,[8][9][10][11][12] after which it was abandoned.[13] Interest in the Muon Collider project has increased again in 2020 after the publication of the physics-reach comparison between the 1.5 TeV Muon Collider and the CLIC experiment,[14] followed by the update of the European strategy for particle physics, in which it was recommended to initiate an international design study of a Muon Collider targeting centre-of-mass energies close to 10 TeV.[15]
See also
[edit]References
[edit]- ^ Lawrence Berkeley Laboratory Center for Beam Physics Archived 27 February 2005 at the Wayback Machine [Retrieved 2012-01-08]
- ^ K. R. Long, D. Lucchesi, M. A. Palmer, N. Pastrone, D. Schulte and V. Shiltsev (2021). "Muon colliders to expand frontiers of particle physics". Nature Physics. 17 (3): 289–292. arXiv:2007.15684. Bibcode:2021NatPh..17..289L. doi:10.1038/s41567-020-01130-x. S2CID 234356677.
{{cite journal}}
: CS1 maint: multiple names: authors list (link) - ^ Jadach, S.; Kycia, R.A. (April 2016). "Lineshape of the Higgs boson in future lepton colliders". Physics Letters B. 755: 58–63. arXiv:1509.02406. Bibcode:2016PhLB..755...58J. doi:10.1016/j.physletb.2016.01.065.
- ^ MICE collaboration (2020). "Demonstration of cooling by the Muon Ionization Cooling Experiment". Nature. 578 (7793): 53–59. Bibcode:2020Natur.578...53M. doi:10.1038/s41586-020-1958-9. PMC 7039811. PMID 32025014.
- ^ M. Antonelli, M. Boscolo, R. Di Nardo and P. Raimondi (2016). "Novel proposal for a low emittance muon beam using positron beam on target". Nucl. Instrum. Methods A. 807: 101–107. arXiv:1509.04454. Bibcode:2016NIMPA.807..101A. doi:10.1016/j.nima.2015.10.097. S2CID 55500891.
{{cite journal}}
: CS1 maint: multiple names: authors list (link) - ^ Eric Hand 18 November 2009 Nature 462, 260–261 (2009) [1] doi:10.1038/462260a [Retrieved 2012-01-08]
- ^ Fermilab The U.S. Department of Energy > MUONRD indico [Retrieved 2012-01-08 (site last modified: 30 September 2011)]
- ^ MAP [Retrieved 2012-01-08 (site last modified: 22 March 2011)]
- ^ Eddy, B. Fellenz, P. Prieto, A. Semenov, D.C. Voy, M. Wendt (Fermilab) 17 August 2011 A Wire Position Monitor System for the 1.3 GHz TESLA-style Cryomodule at the Fermilab New-Muon-Lab Accelerator. [2] [Retrieved 2012-01-08]
- ^ 6 March 2008 – The Neutrino Factory and Muon Collider Collaboration (NFMCC) pdf – 17 October 2011 [Retrieved 2012-01-08]
- ^ Yonehara, Katsuya; MTA working Group (2013). "Recent progress of RF cavity study at Mucool Test Area". Journal of Physics: Conference Series. 408 (1): 012062. arXiv:1201.5903. Bibcode:2013JPhCS.408a2062Y. doi:10.1088/1742-6596/408/1/012062. S2CID 204924736.
- ^ ISIS A World centre for Neutrinos and Muons [3][Retrieved 2012-01-08]
- ^ Dattaro, Laura (10 April 2024). "'This is our Muon Shot' | symmetry magazine". www.symmetrymagazine.org. Retrieved 11 April 2024.
- ^ N. Bartosik, A. Bertolin, L. Buonincontri, M. Casarsa, F. Collamati, A. Ferrari, A. Ferrari, A. Gianelle, D. Lucchesi, N. Mokhov, M. Palmer, N. Pastrone, P. Sala, L. Sestini and S. Striganov (2020). "Detector and Physics Performance at a Muon Collider". Journal of Instrumentation. 15 (5): P05001. arXiv:2001.04431. Bibcode:2020JInst..15P5001B. doi:10.1088/1748-0221/15/05/P05001.
{{cite journal}}
: CS1 maint: multiple names: authors list (link) - ^ CERN Courier Muon-collider study initiated
External links
[edit]- Gibney, Elizabeth (8 August 2022). "Particle physicists want to build the world's first muon collider". Nature. 608 (7924): 660–661. Bibcode:2022Natur.608..660G. doi:10.1038/d41586-022-02122-y. PMID 35941386.