Jump to content

Intermediate-frequency amplifier

From Wikipedia, the free encyclopedia
(Redirected from IF amplifier)
The IF stage from a Motorola 19K1 television set circa 1949.
Discrete transistor 455 kHz IF amplifier.
More modern IF amplifier and demodulator in integrated circuit form

Intermediate-frequency (IF) amplifiers are amplifier stages used to raise signal levels in radio and television receivers, at frequencies intermediate to the higher radio-frequency (RF) signal from the antenna and the lower (baseband) audio or video frequency that the receiver is recovering.[1]

Uses

[edit]

IF amplifiers in heterodyne receivers apply gain in a frequency band between the input radio frequency and output audio frequency or video frequency, often following one stage of RF amplifier. This allows most of the gain in the form of a fixed-frequency amplifier, simplifying tuning. Compare to its predecessor, the tuned RF receiver. IF amplifiers might use double-tuned amplifiers or staggered tuning to generate the appropriate frequency response needed. Some use more than one IF frequency.

Commonly used circuits

[edit]
  • Mutual inductance coupling: contains two windings that are joined by mutual inductance.
  • Shunt capacitance coupling: These circuits have a wide pass band.
  • composite IF transformers: receivers used for A-M and F-M receivers.[2][3]

References

[edit]
  1. ^ Walker, H. R. (2005). "Intermediate-Frequency Amplifiers". Encyclopedia of RF and Microwave Engineering. doi:10.1002/0471654507.eme187. ISBN 978-0471654506.
  2. ^ Sandel, B. "Intermediate Frequency Amplifiers" (PDF). frank.yueksel.org/. Retrieved November 28, 2013.
  3. ^ "The Art of Alignment". www.vintage-radio.net. Retrieved 27 January 2019.
[edit]

Media related to IF amplifiers at Wikimedia Commons