Jump to content

DRG H 02 1001

From Wikipedia, the free encyclopedia
(Redirected from H02 locomotive (Germany))
H 02 1001
A works photograph of H 02 1001
Type and origin
Power typeSteam
BuilderBerliner Maschinenbau
Serial number8831
Build date1929/1930
Total produced1
Specifications
Configuration:
 • Whyte4-6-2
 • UIC2C1 h3v
Gauge1,435 mm (4 ft 8+12 in)
Leading dia.850 mm (2 ft 9+12 in)
Driver dia.2,000 mm (6 ft 6+34 in)
Trailing dia.1,250 mm (4 ft 1+14 in)
Minimum curve140 m (460 ft)
Length:
 • Over buffers23,750 mm (77 ft 11 in)
Adhesive weight60 tonnes (59 long tons; 66 short tons)
Empty weight111.5 tonnes (109.7 long tons; 122.9 short tons)
Service weight115 tonnes (113 long tons; 127 short tons)
Tender type22 T 32
Fuel typeCoal
Fuel capacity10 t (9.8 long tons; 11 short tons)
Water cap.32 m3 (7,000 imp gal; 8,500 US gal)
Firebox:
 • Grate area2.4 m2 (26 sq ft)
Boiler pressure120 bar (122 kgf/cm2; 1,740 psi)
CylindersThree, compound: 2 HP outside, 1 LP inside
High-pressure cylinder220 mm × 660 mm (8+1116 in × 26 in)
Low-pressure cylinder600 mm × 660 mm (23+58 in × 26 in)
Performance figures
Maximum speed110 km/h (68 mph)
Indicated power2,500 PS (1,840 kW; 2,470 hp)
Career
Retired1945
Scrapped1954
DispositionScrapped

The DRG H 02 1001 was a high-pressure steam locomotive built by the engineering firm of Berliner Maschinenbau (formerly L. Schwarzkopff) to the design of Dr L. Löffler.[1] The aim was not only to improve fuel economy—the usual reason for adopting high steam pressures—but also to increase the amount of power that could be produced within the German loading gauge.

The H02 1001 locomotive was the only example of the Schwarzkopff-Löffler high-pressure boiler system, a complex technology in which heat was extracted from the firebox by tubes filled with steam rather than boiling water. It was delivered in 1930 to the Deutsche Reichsbahn (DRG). Schwarzkopff guaranteed in the purchase contract a coal saving of 42% over a standard 01 locomotive design, but in the event the DRG never bought the locomotive.

Steam was delivered at no less than 1,750 lbf/in2 (123 kgf/cm2; 12.1 MPa) to two very small outside cylinders of 220 mm (8+1116 in) diameter. These were compounded with a single 600 mm (23+58 in) LP inside cylinder. The wheel arrangement was 4-6-2.

After extensive trials it was found that any increase in efficiency was small compared with the greatly increased maintenance costs. The very complicated H02 1001 was also hopelessly unreliable.

The H02 1001 was retired from active service in 1945, then cut up for scrap.

See also

[edit]

References

[edit]
  1. ^ "H02". Hochdruck: German High-Pressure Locomotives. Archived from the original on 2 May 2011. Retrieved 24 May 2010.
[edit]