Jump to content

Engineered materials arrestor system

From Wikipedia, the free encyclopedia

EMAS bed after being run over by landing gear

An engineered materials arrestor system, engineered materials arresting system (EMAS), or arrester bed[1] is a bed of engineered materials built at the end of a runway to reduce the severity of the consequences of an aircraft running off the end of a runway. Engineered materials are defined in FAA Advisory Circular No 150/5220-22B as "high energy absorbing materials of selected strength, which will reliably and predictably crush under the weight of an aircraft". While the current technology involves lightweight, crushable concrete blocks, any material that has been approved to meet the FAA Advisory Circular can be used for an EMAS. The purpose of an EMAS is to stop an aircraft overrun with no human injury and minimal aircraft damage. The aircraft is slowed by the loss of energy required to crush the EMAS material. An EMAS is similar in concept to the runaway truck ramp or race circuit gravel trap, made of gravel or sand. It is intended to stop an aircraft that has overshot a runway when there is an insufficient free space for a standard runway safety area (RSA). Multiple patents have been issued on the construction and design on the materials and process.

Plan view, profile view, section view of a typical EMASMAX system.

FAA Advisory Circular 150/5220-22B explains that an EMAS may not be effective for incidents involving aircraft of less than 11,000 kilograms (25,000 lb) weight.[2] It also clarifies that an EMAS is not the same as a stopway, which is defined in FAA Advisory Circular 150/5300-13A, Section 312.[3] Pilots are advised, if they know the airplane is going to overrun onto an EMAS installation, to maintain directional control of the aircraft and roll straight into it. By doing this, the aircraft will come to a complete stop over a short distance, regardless of the runway conditions or braking action being experienced.[4]

As of May 2017, the International Civil Aviation Organization (ICAO) has been working on developing a harmonized regulation regarding arresting systems.

Research projects completed in Europe have looked into the cost-effectiveness of EMAS. Arrestor beds have been installed at airports where the runway safety areas are below standards, and their ability to stop aircraft with minimal or no damage to the air frame and its occupants has proven to bring results far beyond the cost of installations. The latest report, "Estimated Cost-Benefit Analysis of Runway Severity Reduction Based on Actual Arrestments", shows how the money saved through the first 11 arrestments has reached a calculated total of 1.9 billion USD, thus saving more than $1 B over the estimated cost of development (R&D, all installations worldwide, maintenance and repairs reaching a total of USD 600 million). The study suggests that mitigating the consequences of runway excursions worldwide may turn out to be much more cost-effective than the current focus on reducing the already very low probability of occurrence.[5]

United States installations

[edit]
EMAS under construction. The slope part on the left is a blast shield.[6]
Higher EMAS bed with side steps to allow aircraft rescue and firefighting (ARFF) access and passenger egress.[6]

The FAA's design criteria for new airports designate Runway Safety Areas (RSAs) to increase the margin of safety if an overrun occurs and to provide additional access room for response vehicles. A United States federal law required that the length of RSAs in airports was to be 1,000 feet (300 m) by the end of 2015, in a response to a runway overrun into a highway at Teterboro Airport in New Jersey.[1] At airports built before these standards were put into effect, the FAA has funded the installation of EMAS at the ends of main runways. The minimum recommended overall length of an EMAS installation is 600 feet (180 m), of which at least 400 feet (120 m) is to consist of the frangible material.[7]

As of April 2019, ESCO's EMAS is installed at 112 runway ends at 68 airports in the United States, with plans to install three EMAS systems at two additional U.S. airports.[8]

As of 2017 the FAA reported that EMAS systems had been used 12 times, but that in some situations pilots tried to avoid the EMAS, steering to the grass sides in 30–40 kn (56–74 km/h; 35–46 mph) low-energy events in order to avoid publicity.[9]

Non-U.S. installations

[edit]

Of the 15 non-U.S. installations, eight were provided by Zodiac Arresting Systems (two in China, two in Madrid, one in Taipei, Taiwan (Songshan Airport), two in Norway and one in Saudi Arabia), six were provided by RunwaySafe (one in Switzerland, and three in overseas departments of France – one in Reunion Island, two in Mayotte), one in Japan, one in Germany, two in Brazil and one provided by Hankge (China).

FAA-approved manufacturers

[edit]

As of February 2018, there were three recognized EMAS materials (from two manufacturers worldwide) that meet the FAA requirements of Advisory Circular 150-5220-22B, "Engineered Materials Arresting Systems for Aircraft Overruns." (The FAA must review and approve each EMAS installation.)[10]

The first EMAS was developed in the mid-1990s by ESCO/Engineered Arresting Systems Corp. (later Zodiac Arresting Systems) as part of a collaboration and technical acceptance by the FAA. The fourth generation EMAS arrestor beds are composed of blocks of lightweight, crushable cellular concrete material, encased in jet blast resistant protection, designed to safely stop airplanes that overshoot runways. Zodiac's EMAS is installed on over 110 airport runways at over 65 airports on three continents.[when?] Zodiac's EMAS has undergone aircraft test runs at speeds up 55 knots (102 km/h; 63 mph) and is the only EMAS that has safely stopped aircraft in emergency overrun situations at commercial airports. Zodiac stopped production of EMAS systems as the U.S market slowed down and competition increased in the international market.[11]

The Swedish company Runway Safe AB developed an EMAS system, a foamed silica bed made from recycled glass contained within a high-strength plastic mesh system anchored to the pavement at the end of the runway. The foamed silica is poured into lanes bounded by the mesh and covered with a poured cement layer and treated with a top coat of sealant.[12]

A third manufacturer, certified by the Chinese CAAC, has a product that is very similar to the original Zodiac EMAS, but it is not FAA approved, as presented by International Civil Aviation Organization (ICAO) at 02/08/2019 in report A40-WP/331.[13]


Incidents

[edit]
  • In May 1999, a Saab 340 commuter aircraft with 30 persons aboard overran the runway at JFK.
  • In May 2003, a Gemini Cargo MD-11 cargo aircraft with 3 persons aboard overran the runway at JFK.
  • In January 2005, a Boeing 747 cargo aircraft with 3 persons aboard overran the runway at JFK.
  • In July 2006, a Mystere Falcon 900 business aircraft with 5 persons aboard overran the runway at Greenville Downtown Airport in South Carolina.
  • In July 2008, an Airbus A320 commercial airliner with 145 persons aboard overran the runway at Chicago's O'Hare Airport.
  • On 19 January 2010, a Bombardier CRJ-200 commercial regional airliner with 34 persons aboard overran the runway at Yeager Airport in Charleston, West Virginia after a rejected takeoff.[14]
  • On 1 October 2010, a G-4 Gulfstream business aircraft with 10 persons aboard overran the runway at Teterboro Airport in Teterboro, New Jersey.[15]
  • On 2 November 2011, a Cessna Citation II business aircraft with 5 persons aboard overran the runway at Key West International Airport in Key West, Florida.[16][17]
  • In October 2013, a Cessna 680 Citation business aircraft with 8 persons aboard overran the runway at Palm Beach International in West Palm Beach, Florida.
  • In January 2016, a Dassault Falcon 20 aircraft with 2 persons aboard overran the runway at Chicago Executive Airport in Wheeling, Illinois.[18]
  • In October 2016, a Boeing 737 aircraft with 37 persons aboard, including Republican vice-presidential candidate Mike Pence, overran the runway at LaGuardia Airport, New York.[19][20][21]
  • In April 2017, a Cessna 750 Citation aircraft with 2 persons aboard overran the runway at Bob Hope Airport in Burbank, California.
  • In December 2018, a Boeing 737 aircraft with 117 persons aboard overran Runway 8 at Bob Hope Airport in Burbank, California.[22]
  • On 27 February 2019 an Embraer Phenom 100 operated by Quest Diagnostic Laboratories overran a runway at the Charles B. Wheeler Kansas City Downtown Airport (KMKC) at 4:28am local time resulting in the safe stopping of the aircraft with the pilot being the only occupant aboard.

Additional media coverage of EMAS statistics, installations, and general news include:

See also

[edit]
  • Arresting gear - a cable-based system used to arrest an aircraft, used particularly on aircraft carriers

References

[edit]
  1. ^ a b Boburg, Shawn (17 September 2013). "Teterboro Airport gets $1M for runway project". northjersey.com. Archived from the original on 5 May 2014. Retrieved 5 May 2014.
  2. ^ [1] FAA Advisory Circular 150/5220-22B (PDF)
  3. ^ "Archived copy" (PDF). Archived from the original (PDF) on 21 February 2015. Retrieved 20 February 2015.{{cite web}}: CS1 maint: archived copy as title (link) FAA Advisory Circular 150/5300-13A (PDF)
  4. ^ Freeze, Christopher; Sedin, Jeff (August 2021). "EMAS: Don't Swerve, Go Straight Ahead". www.alpa.org. Air Line Pilots Association. Retrieved 18 May 2023.
  5. ^ "Estimated Cost-Benefit Analysis of Runway Severity Reduction Based on Actual Arrestments" (PDF).
  6. ^ a b Jacobs, Kenneth (1 March 2006). "Runway Safety Areas - An Airport Operator's Perspective". Federal Aviation Administration. pp. 8, 9, 13. Archived from the original on 27 September 2012. Retrieved 20 August 2014.
  7. ^ FAA AC 150-5220
  8. ^ "Fact Sheet – Engineered Material Arresting System (EMAS)". Federal Aviation Administration. Retrieved 8 April 2019.
  9. ^ John Croft (2 August 2017). "FAA Confirms Cases of EMAS Phobia". Aviation Week Network.
  10. ^ "AC 150/5220-22B - Engineered Materials Arresting Systems (EMAS) for Aircraft Overruns".
  11. ^ "Fact Sheet – Engineered Material Arresting System (EMAS)". Archived from the original on 16 July 2012.
  12. ^ FAA Fact Sheet – Engineered Material Arresting System (EMAS)
  13. ^ International Civil Aviation Organization (ICAO), Engineered Materials Arresting System (EMAS) A Implementation In China, vol. A40-WP/331. 2019, p. 3–5.
  14. ^ "PSA Airlines Canadair CRJ-200 N246PS operating as US Airways flight 2495 from Charleston, West Virginia (CRW) to Charlotte, North Carolina (CLT) with 30 passengers [sic] and 3 crew, overran the runway following a rejected take-off. The aircraft was stopped by the EMAS at the end of the runway, sustaining only minor damage to its landing gear doors."
  15. ^ "Private jet overshoots runway at Teterboro Airport". Archived from the original on 29 March 2012. Retrieved 28 October 2016.
  16. ^ "A Cessna Citation landed at Key West. The flight, which originated in Fort Lauderdale with 3 passengers and 2 crew, had a brake failure upon landing in Key West and was successfully stopped by the airport's newly installed EMAS. Only minor injuries were reported.""No one is hurt after small plane crash lands at Key West Airport". NJ.com. 4 November 2011. Retrieved 24 August 2012.
  17. ^ "Aviation Accident Brief ERA12IA060". NTSB.
  18. ^ "EMAS Saves Falcon 20 at Chicago Executive". Aviation International News. Retrieved 16 May 2017.
  19. ^ Mele, Christopher (27 October 2016). "Plane With Mike Pence Aboard Skids Off La Guardia Runway". The New York Times. ISSN 0362-4331. Retrieved 28 October 2016.
  20. ^ Walker, Karen (27 October 2016). "LaGuardia runway EMAS saves US VP candidate aircraft". Air Transport World. Retrieved 29 October 2016.
  21. ^ Hradecky, Simon. "Accident: Eastern Air Lines B737 at New York on Oct 27th 2016, overran runway on landing long". avherald.com. Retrieved 30 October 2016.
  22. ^ Ranter, Harro. "Runway excursion Incident Boeing 737-7H4 (WL) N752SW, 06 Dec 2018". aviation-safety.net. Retrieved 6 December 2018.
  23. ^ "KMDW Airport Diagram". Retrieved 7 January 2008.
  24. ^ Oldham, Jennifer (14 October 2006). "Yankee Player's Jet Overruns Runway in Burbank". Los Angeles Times. The airport installed the $4-million safety system after a Southwest Airlines Boeing 737 skidded off the same runway and onto a street in 2000, injuring 43 passengers and the captain on the same runway.
  25. ^ [2] FAA Fact Sheet
[edit]
Retrieved from "https://wiki.riteme.site/w/index.php?title=Engineered_materials_arrestor_system&oldid=1258886512"