Aerodis AA200 Orion
| AA200 Orion | |
|---|---|
| Role | light aircraft |
| National origin | USA |
| Manufacturer | Aerodis |
| Designer | David Thurston[1] |
| First flight | April 7, 1991[1] |
The Aerodis AA200 Orion is a four-seat prototype light aircraft designed in the United States and which first flew on April 7, 1991.[1] Aerodis commissioned the design with the intention of developing a family of related aircraft sharing a common basic airframe,[1] including the AA300 Rigel and AA330 Theta. Aerodis was also the American distributor for the Grinvalds Orion, a French light aircraft intended for homebuilding. Although the Aerodis Orion and Grinvalds Orion shared a same basic configuration and composite construction, the two aircraft were not further related, and the AA200 was an all-new design.[2] The designs are sometimes known as the CRSS AA200 Orion, CRSS AA300 Rigel, and CRSS AA330 Theta after the rights to the designs were sold to Indonesian manufacturer CRSS.[3]
Design and development
[edit]The Orion is a low-wing cantilever monoplane with a T-tail, prominent ventral fin, and retractable, tricycle undercarriage.[2] It is powered by a mid-mounted piston engine driving a pusher propeller though a long driveshaft.[2] Construction throughout is of composite materials.[2] The enclosed cabin seats four people in 2+2 configuration.
Aerodis planned to use this design as the basis for a jet trainer aircraft, the AA300 Rigel, and a light tactical aircraft, the AA330 Theta.[2] In both these cases, the piston engine was to be replaced by a small turbofan, either the Garrett F109 or Williams FJ44,[2] and the cockpit was to be enclosed by a bubble canopy.[2] The Rigel was to seat pilot and instructor in tandem, while the Theta was to be a single-seat aircraft fitted with an ejector seat.[2] Aerodis presented both designs at the 1989 Paris Air Show.[4]
Two prototypes of the Rigel were under construction in 1991 for entry into the US Department of Defense Joint Primary Aircraft Training System competition,[2][5] one to test each of the prospective powerplants.[5] Aerodis was unable to attract sufficient investment to complete the prototypes or continue development.[4]
Manufacturing of Aerodis designs was to have been carried out by Cipta Restu Sarana Svaha (CRSS) in Indonesia.[1] In 1991, Aerodis sold the whole program to CRSS.[6]
Specifications (AA200)
[edit]Data from Lambert 1991, p.337
General characteristics
- Crew: 1 pilot
- Capacity: 3 passengers
- Length: 25 ft 5 in (7.75 m)
- Wingspan: 30 ft 0 in (9.14 m)
- Height: 8 ft 7 in (2.62 m)
- Wing area: 137 sq ft (12.7 m2)
- Empty weight: 1,400 lb (635 kg)
- Max takeoff weight: 2,500 lb (1,134 kg)
- Powerplant: 1 × Lycoming O-360 4-cylinder, horizontally-opposed, air-cooled piston engine, 180 hp (130 kW)
Performance
- Maximum speed: 180 kn (210 mph, 330 km/h)
- Cruise speed: 165 kn (190 mph, 306 km/h)
- Range: 780 nmi (900 mi, 1,440 km)
- Service ceiling: 14,500 ft (4,400 m)
- Rate of climb: 1,020 ft/min (5.2 m/s) (max. at sea level)
- Wing loading: 18.25 lb/sq ft (89.1 kg/m2)
- Power/mass: 13.89
References
[edit]Notes
[edit]Bibliography
[edit]- "First-flight Delay for AA300 Rigel trainer". Flight International. March 27, 1991.
- Gunston, Bill (1993). World Encyclopedia of Aircraft Manufacturers. Anapolis, Maryland: Naval Institute Press.
- Lambert, Mark (1991). Jane's All The World's Aircraft 1991–92. Coulsdon: Jane's Data Division.
- Taylor, Michael J. H. (1993). Jane's Encyclopedia of Aviation. London: Studio Editions.
- Subodo, Sudiro (31 July 2020). "Pesawat Latih Jet Buatan Indonesia, Antara Ambisi dan Oportunis" [Jet Training Aircraft Made in Indonesia: Between Ambition and Opportunism]. AviaHistoria: Aviation History of Indonesia. Retrieved 4 June 2024.